大学英语词汇短语释义解析及例句 contact resistance
释义：
contact resistance 接触电阻：指两个导体接触时产生的电阻，通常由于接触面的不规则性、氧化物和其他杂质等因素导致
例句：
Contact resistance modeling.
接触电阻建模。
The contact resistance is difficult to measure.
接触阻力很难测量。
A model of contact resistance for a microswitch is presented.
建立了一个微开关接触电阻模型。
In addition, the contact resistance also influences the test value.
另外，接触电阻对测试值有一定影响。
This average reading removes some of the effect of contact resistance.
平均读数法去除了接触电阻的某些影响。
This method can carry out the quantitative measurement of contact resistance.
该方法能够实现接触电阻的定量测量。
For dry switches, the contact resistance is inversely related to the contact area.
对于干式开关，接触电阻与接触面积成反比关系。
This causes contact resistance failures, which will be discussed later in this section.
这会导致接触电阻故障。关于该问题将会在本章随后讨论。
The experimental principles and equipment of thermal contact resistance were introduced.
介绍了接触热阻的测量原理和传统的实验装置。
Figure 4-42 illustrates a basic configuration for testing contact resistance of a contact.
图4 -42说明用来测试一个接点的接触电阻的基本配置。
We measured the resistance and the contact resistance of the pentacene by using such method.
利用以上测量方案我们对并五苯单晶材料的电阻率和接触电阻进行了测量。
The contact resistance between contacts is composed of contraction resistance and velamen resistance.
电器触点间的接触电阻包括收缩电阻和薄膜电阻。
It is found that the magnitude and stability of contact resistance greatly affect the measuring results.
发现接触电阻的大小和稳定程度对测量结果有极大的影响。
I do ultra-small resistance test equipment, the general used to test the relay switch contact resistance!
我做的测试超小阻值的仪器，一般用来测试开关继电器的接触电阻！
Coarseness effects on contact resistance of electric contacts, especially, light_duty ones were analyzed.
分析了粗糙度对电触头，尤其是轻负载用电触头接触电阻的影响。
According to the experiment results, the formula used to calculate the thermal contact resistance was adjusted.
根据实验结果，对接触热阻的计算公式进行了修正。
The existence of the contact resistance must be considered when accurate thermal conductivity measurements are performed.
如果要精确地测量热导率，就必需考虑接触阻力的存在问题。
The design of measuring system of dynamic contact resistance is achieved, including: hardware design and software design.
完成了导电环动态接触电阻测量系统的总体设计，包括硬件电路设计和软件设计。
Conduction resistance test should take the effect of base point, contact resistance, and on-site disturbance into account.
导通电阻测试需注意参考点(基准点)选择、接触电阻及现场干扰的影响。
A new model of thermal contact resistance based on the statistic characteristic of roughness profile is proposed in this paper.
本文在对粗糙度曲线统计特征分析的基础上，提出了一种接触热阻的计算模型。
